Eureka / Glass walls

The glass walls are not supplied with standard sizes, but
entirely on demand.

Profiles
The profiles are made of three different kinds of extruded
anodized aluminium or of aluminium with an epoxy powder
painted finish. The floor and ceiling slides are U elements
in which the two glass-holder profiles with a gasket
and latch are fastened. The glass-holder profiles are also
used as a starting point from the walls and as a vertical
seal close to the doors.

Glass
The glass is supplied in 10 mm-thick sheets of monolithic
float. The length and height are defined specifically
for each project. During installation, the sheets are vertically
sealed by means of an extruded aluminium profile
with a very narrow section.

Doors
The doors are made of 10 mm-thick tempered float glass
with a maximum height of 2200 mm. For higher doors,
the thickness of the glass must be 12 mm.
They can be either sliding or leaf doors. The leaf doors can
be supplied either with pivoting anodized silver aluminium
hinges fixed to the floor and ceiling or with MBA-type
hinges embedded in the floor, and with traditional
or “push open” handles.
The sliding doors are available at a height of up to 3000 mm,
and are equipped with a sliding external hanging system.
The slides must be fastened to permanent architectonical
elements. The door bars are made of tubular
anodized silver aluminium, and are 300 mm long.
Other sizes are available upon request.